As an Amazon Associate I earn from qualifying purchases from amazon.com.au

Water in the woodshop – FineWoodworking


If you’re one of the last few who have running water in your wood shop, just hit stop, move on. But if you’re like me and your shop is 50 or 60 feet away from running water, you’ve had to figure out some workarounds. I keep a couple of gallons of water in a jug in my shop, which I wind up having to fill this up about once a week. But there’s a couple little things that I’ve gotten over the past few months that have really helped my flow in the shop.

Glue brush cup

One of them is this paintbrush cleanup container–which it turns out is called a “neatness jar”. It’s just a lidded cup that I fill with an inch or so of water. The lid keeps the water from evaporating. Under the lid is a cone inside with a hole in it which is this is a great place to tamp your brush clean. Most of the time, when I finish spreading glue with my glue brush, I just throw the brush right in the cup and the water keeps the glue from drying; then after I’m done with the stress of dealing with clamps and getting parts to fit together, I go back and clean up my brush.

Spray bottles

I do a lot of hot-pipe bending and I often use a spray bottle to moisten the wood before bending. A spray bottle of water comes in handy to spray a piece down in order to raise the green before final sanding. Recently I was helping my brother sand a buthcher-block countertop and I asked him for a spray bottle. My sister in law came with what can only be described as a magic spray bottle–a continuous-flow spay bottle. She ordered it online, but I’m sure they’re available at beauty supply stores. The continuous-flow bottle puts out a really fine mist, so one spray from it is is probably equal to one spray from a regular sprayer. If I were a water-stone sharpener, I would absolutely have one a continuous-flow bottle–besides, it’s just kind of fun.

So how do you use water in your woodshop if you don’t have running water? Move on. Let me know in the comments below. I’m interested.


A Water Supply in the Shop

I needed a water supply in my shop but found it wasn’t practical or cost effective to extend the household plumbing.

Inexpensive Substitute for a Sharpening Sink

Because I don’t have a sink in my shop, I used to use a squirt bottle to wet my waterstones during sharpening, but that was tedious and interrupted the sharpening…

Sign up for eletters today and get the latest techniques and how-to from Fine Woodworking, plus special offers.

Get woodworking tips, expert advice and special offers in your inbox

×






Source link

We will be happy to hear your thoughts

Leave a reply

Mumfaz
Logo
Enable registration in settings - general
Compare items
  • Total (0)
Compare
0
Shopping cart